50
Minutes (flashing)
Hours (flashing)
The time zone default is "0 hour". To set a different time zone:
1. The current time zone value starts flashing.
2. Use the + key to set the time zone. The range runs from 0, -1, -2…-12, 12, 11, 10… 2, 1, 0, in
consecutive 1-hour intervals.
3.
Confirm with the SET key and enter the Manual Time setting.
MANUAL TIME SETTING
In case the Weather station is not able to detect the radio-controlled time (DCF time) signal (disturbances,
transmitting distance, etc.), the time can be manually set. The clock will then work as a normal Quartz
clock.
To set the clock:
1. The hour digits start flashing in the time display section.
2. Use the + key to adjust the hours and then press SET key to go to the minute setting.
3. The minute will be flashing. Press the + key to just the minutes.
4. Confirm with the SET key and enter the “Calendar Setting”.
To Next Page
Loading...
