stops. (“ ” on LCD disappear) and repeats again on next full hour. E.g. scanning
failed at 8:20a.m. It will scan again at 9:00a.m.
Stop scanning by holding “ ” button (B
5) for 3 seconds.
“DST” shown on the LCD if it is in Daylight Saving Time Mode
Note: Buttons will not function while scanning for DCF time signal unless they are
well received or stopped manually.
4.2 Manual Time Setting:
In time display mode, hold “MODE” button (B1) for 3 seconds to enter
Clock/Calendar setting Mode.
Press “+” (B4) or “-” (B5) button to adjust the setting and press “MODE” button
(B1) to confirm each setting.
(By keeping the “+” (B4) or “-” (B5) button pressed, could accelerate the process
and reach the desired value more quickly)
The setting sequence is shown as follow: Hour, Minute, Second, Year, Month/Day
sequence, Month, Date, Weekday Language, Time Zone
There are 8 languages for day of week: German, English, French, Italian, Dutch,
Spanish, Denmark and Russian. The languages and their selected abbreviations
for each day of the week are shown in the following table.
Note:
(1) All Sett
ing mode will automatically exit in 15 seconds without any adjustment
(2) For Time Zone: If you receive no RC-DCF frequency signal, the time zone should be
set to 0. Time Zone is used in countries which can received the DCF frequency
signal but the time zone is different from German Time ( i.e. GMT+1).
4.3 Daily Alarm Function:
English - 3