EN3
attempt another synchronization at the next full one hour. This procedure is repeated
automatically up to total 5 times.
To manually start DCF signal reception, press the “WAVE” button once. If no signals received
within 7 minutes, then the DCF signal search stops (the radio mast icon disappears) and start
again at the next full one hour.
To stop searching radio signal, press the “WAVE” button once.
Notes:
A flashing radio mast icon indicates that the DCF signal reception has started
A continuously displayed radio mast icon indicates that the DCF signal was received
successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as
televisions or computer monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such
extreme circumstances, place the system close to the window.
During the DCF radio receive mode, only the “WAVE” button function, other button
operation have no function, If you want to carry out other functions of operation, please press
“WAVE” button to exit the DCF radio receive mode.
Selecting RCC mode on/off:
Hold the “WAVE” button until the beep tone sounds and “RCC OFF” is shortly displayed on the
LCD. The clock is now no longer using radio-controlled function.
Hold the “WAVE” button again until the beep tone sounds and “RCC ON” is shortly displayed
on the LCD. The clock is using radio-controlled function again.
12-hour or 24-hour time display setting:
Press the “DOWN” button to change the time displayed in 12-hour or 24-hour display.
Manual time setting:
Press and hold down the “SET” button for 2 seconds, the button BEEP sound settings: ON or
OFF is displayed. Press the “UP” or “DOWN” button to set BEEP in ON or OFF.
Press “SET” to confirm your setting, the time zone starts to flash. Press the “UP” or “DOWN”
button to set a correct time zone (-2 to +2). For example, select "0" for Germany or "-1" for the
United Kingdom.
Press “SET” to confirm your setting, the hour display starts to flash. Press the “UP” or “DOWN”
button to set the correct hour.
Press “SET” to confirm your setting, the minute displays starts to flash. Press the “UP” or
“DOWN” button to set the correct minute.
Press “SET” to confirm your setting, the year display 2018 starts to flash. Press the “UP” or
“DOWN” button to set the correct year.
Press “SET” button to confirm your setting, the month display starts to flash. Press the “UP” or
“DOWN” button to set the correct month.
Press “SET” button to confirm your setting, the date display starts to flash. Press the “UP” or
“DOWN” button to set the correct date.
Press “SET” button to confirm your setting, the language selection starts to flash. Press the
“UP” or “DOWN” button to select a language.
Press “SET” to confirm your setting and to end the setting procedures, enter the clock mode.
Notes:
After 20 seconds without pressing any button, the clock switches automatically from set mode
to normal time mode.
The value of seconds is automatically reset to 00 if the value of minutes is changed.
In the set time, you can hold the “UP” and “DOWN” button to quickly change the setting of the
value
To Next Page
Loading...
Need help?
General
