TECHWOOD DDR 94 User Manual

Remote Control Unit
10
By using the provided remote control unit, the receiver and
some other components including Techwood models
DVDC94, DVDC95, CDC86,CDC85, and TDX85 can be
controlled from your listening position.
To use the remote control unit, point it at the REMOTE
SENSOR window of the receiver(or other component).
Notes:
< Even if the remote control unit is operated within the
effective range, remote control operation may be
impossible if there are any obstacles between the unit
and the remote control.
< If the remote control unit is operated near other
appliances which generate infrared rays, or if other
remote control devices using infrared rays are used near
the unit, it may operate incorrectly.
Remove the battery compartment cover.
Insert two "AAA" (R03, UM-4) dry batteries.
Make sure that the batteries are inserted with their
positive "+ " and negative "_ " poles positioned correctly.
Close the cover until it clicks.
< If the distance required between the remote control unit
and main unit decreases, the batteries are exhausted.
In this case replace the batteries with new ones.
3
2
1
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+ "
and negative "_ " polarities.
< Use batteries of the same type. Never use different types
of batteries together.
< Rechargeable and non-rechargeable batteries can be
used. Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they
leak, wipe away the liquid inside the battery
compartment and replace the batteries with new ones.
< Do not heat or disassemble batteries and never dispose
of old batteries by throwing them in a fire.
REMOTE
SENSOR
REMOTE SENSOR window
of the receiver or other
component
Remote sensor
Remote Control unit
Battery lnstallation
tape deck operation buttons
When used with Techwood model TDX85.
CD/DVD operation buttons
When used with Techwood models DVDC94, DVDC95,
CDC85 or CDC86.
B
A
Notes:
< To simplify explanations, this manual refers to names of
buttons and controls on the front panel, making no
mention of the use of remote control unit.
< The power is turned on/off (standby) by pressing the
POWER button on the remote control unit in standby
mode.
Buttons for the Operation of Other
Components
VIDEO2

TECHWOOD DDR 94 Specifications

General

Brand	TECHWOOD
Model	DDR 94
Category	Receiver
Language	English