TECHWOOD DDR 94 User Manual

15
Radio Reception
Using this method, the required frequency is input directly,
using the numeric keys on the remote control unit.
Press the TUNER button.
Select the AM or FM by pressing the BAND selector
button.
Press the DIRECT TUNING button on the remote control
unit.
''DIRECT IN'' appears on the display for a few seconds.
''FM---.--MHz'' or ''AM----kHz'' appears on the display.
Input the frequency of the broadcast you want to hear
with the numeric keys.
< If you press the DIRECT TUNING button again or without
pressing any button for 30 seconds, Direct tuning is
released.
4
3
2
1
FM: 100 kHz steps
AM: 10 kHz steps
Ex.: FM 107.5 MHz
Ex.: AM 1000 kHz
Direct Tuning
Select the TUNER mode by turning the FUNCTION
selector.
1
To store more stations, repeat steps to .
64
While the "MEMO" indicator is lit, select a preset
channel to store the station using the PRESET buttons,
and then press the MEMORY button.
6
Press the MEMORY button briefly.
5
Select the frequency you want to preset by pressing the
PRESET button.
4
Press the MODE(TUNING) button to change the tuning
mode from preset to manual.
The PRESET CH. indicator disappears from the display.
3
Select the AM or FM by pressing the BAND selector
button.
2
2
1
4 5
6
6
3
Manual Memory Presetting

TECHWOOD DDR 94 Specifications

General

Brand	TECHWOOD
Model	DDR 94
Category	Receiver
Language	English