72
Instruction and maintenance manual
ENGLISH
Figure 8.7L - Flattening, contouring and boring of cast iron
parts
Figure 8.7M - 3D machining
Figure 8.7I - Flattening and contouring of cast and molded
parts
Figure 8.7N - Machining of plates with horizontal axis
9
MAINTENANCE
9.1 Premise
A correct maintenance signicantly inuences the
life cycle of the system, ensures a high performance
and fault-free operation, along with maximum func-
tional safety.
9.2 Safety precautions applicable to
maintenance
ATTENTION
Always verify that all maintenance operations are
carried out by qualied and trained personnel (para-
graph 1.7).
While performing maintenance operations, always
take into account the following:
•
All maintenance operations should be performed
when the system is idle and disconnected from
the power supply.
•
All reparations on electric systems must be per-
formed after disconnecting the system from the
power supply and enabling the emergency but-
ton. All personnel responsible for the operation,
maintenance and cleaning of the system shall
have to thoroughly follow the safety instructions
applicable to the country of installation.
•
Always wear safety gloves and shoes and any
other type of PPE required including overalls that
cover as much of the body as possible.
•
Do not wear rings, watches, chains, bracelets,
loose clothing, etc. during maintenance work.
•
Stand on a rubber insulating mat (if possible)
when doing maintenance work.
•
Avoid working on wet oors or under very damp
conditions.
•
Always perform maintenance operation according
to schedule.
• Always replace components with original
spare parts in order to guarantee maximum
performance.
•
When performing cleaning operations, avoid us-
ing grinders or abrasive, corrosive or solvent ma-
terial that could cause the removal and/or make
numbers, initials or information printed on the
system illegible.
•
Protect all electric and electronic equipment from
water.
To Next Page
Loading...