TECO E510s Series - Page 4

3
 The motor will restart automatically after stop when auto-restart function is enabled. In
this case, care must be taken while working around the drive and associated
equipment.
 Confirm that no run command is active upon resetting the alarm or fault, otherwise
accidents may occur.
 If automatic restart after power recovery (parameter 07-00) is enabled, the inverter will
start automatically after power is restored
 Do not touch inverter terminals when energized even if inverter has stopped,
otherwise electric shock may result.
 It is not permissible to open the equipment until 5 minutes after the power has been
removed.。(if the inverter rating is 15HP above, please open the equipment until 15
minutes after the power has been removed.
Caution
 Do not touch heat-generating components such as heat sink and braking resistors.
 Carefully check the performance of motor or machine before operating at high speed,
otherwise Injury may result.
 Note the parameter settings related to the braking unit when applicable.
 After the power is turned off, the cooling fan may continue to run for some time.
 Do not check signals on circuit boards while the inverter is running.
1.5 Maintenance, Inspection and Replacement
Warning
 Wait a minimum of five minutes after power has been turned OFF before starting
an inspection. Also confirm that the charge light is OFF and that the DC bus
voltage has dropped below 25Vdc.
 Never touch high voltage terminals in the inverter.
 Make sure power to the inverter is disconnected before disassembling the inverter.
 Only authorized personnel should perform maintenance, inspection, and replacement
operations. (Take off metal jewelry such as watches and rings and use insulated
tools.)
Caution
 The Inverter can be used in an environment with a temperature range from 14°
~104(°F) or -10~+50(°C1.6) and relative humidity of 95% non-condensing.
 The inverter must be operated in a dust, gas, mist and moisture free environment.
* -10℃~+50℃ (suitable for the product which without dust cover or sticker)
* -10℃~+40℃ (suitable for the product which with dust cover or sticker)
1.6 Disposal of the Inverter
Caution
 Please dispose of this unit with care as an industrial waste and according to your
required local regulations.
 The capacitors of inverter main circuit and printed circuit board are considered as
hazardous waste and must not be burned.
 The Plastic enclosure and parts of the inverter such as the top cover board will release
harmful gases if burned.
Equipment containing electrical components may not be disposed of together with
domestic waste. It must be separately collected with electrical and electronic waste
according to local and currently valid legislation.