TECO A510 User Manual

Page 1 of 10 11/07/14
TECO A510 Inverter
Quick Start Guide
1) Ensure that the Inverter & the motor have the correct
KW power and voltage ratings.
Motor full load amps must not exceed the Inverter rating.
2) Ensure that the supply & Motor cables are connected
Correctly prior to power up.
3) Connect supply cable to terminals L1,L2& L3.
4) Connect motor cable to terminals T1,T2 &T3.
(Swap two leads If motor runs in reveres direction).
5) Connect supply Earth and the motor Earth to the drive Earth
terminal.
Note:-
I ) For detailed installation
and wiring refer to the
Instruction
manual.
This guide is to assist you in installing and running the inverter and verify that it is
functioning correctly for it’s main and basic features.
For detailed information and if there are any doubts please refer to the instruction manual.
Step 1
Supply & Motor connection

TECO A510 Specifications

General

Brand	TECO
Model	A510
Category	Inverter
Language	English

Summary

Quick Start and Basic Setup

Supply & Motor Connection

Guides the user through connecting the inverter to the motor and power supply.

Apply Power to the Drive

Details the process of applying power and initial drive display indications.

Test Run from Keypad

Explains how to perform a basic test run using the inverter's keypad.

Alter Frequency from Keypad

Instructs on changing the operating frequency using the keypad controls.

Remote Operation and Control

Remote Mode Wiring

Covers wiring requirements for remote speed reference and run signals.

Remote Mode Run

Explains how to operate the inverter in remote mode via analog signals.

Verify Remote Control Parameters

Guides on checking and altering parameters for remote start and frequency.

RUN Using Remote Speed Reference

Details activating the run command and setting speed via remote inputs.

Parameter Configuration

How to Alter Parameters from Keypad

Provides step-by-step instructions for modifying inverter parameters.

Keypad Functions Overview

Describes the functions of the inverter's keypad buttons and displays.

Parameter Reference List

Basic Quick Start Parameter List

Lists essential parameters, their default values, ranges, and notes.

Advanced Control Modes and Tuning

Control Modes & Auto Tune

Introduces the inverter's five control modes and auto-tuning capabilities.

V/f Mode Parameters

Details parameters specific to the V/f control mode.

SLV & SV Mode Parameters

Outlines parameters for Sensorless Vector (SLV) and Vector (SV) modes.

Automatic Tuning Function Group

Explains the settings and execution of automatic motor tuning.

Wiring Diagram

Wiring Diagram

Illustrates the electrical connections for the inverter and external components.