TECO A510 - RUN Using Remote Speed Reference; Parameter Configuration; How to Alter Parameters from Keypad

Page 4 of 10 11/07/14
How to alter parameters
Step 4
RUN using remote speed reference.
(Potentiometer, 0-10vdc or 4-20ma )
1) To run. Activate the remote run switch connected to terminals
S1 ( FWD) or S2 ( REV) as required,. Parameter 00-02=0001
The frequency will ram up to the frequency set by one of the
Following and according to the set acceleration ramp time.
Select Analogue input 1 or 2 as required to set speed reference.
 External Analogue Input. Parameter 00-05 = 1
AI1
Voltage Input. Speed command
0 to +10V,
-10V to +10V
AI2
Multi-function analog input terminal.
Use SW2 to switch voltage or current input .
0 to +10V,
-10V to +10V
4 to 20 mA
2) To Stop. De-activate the remote run switch. The frequency will ramp
down to zero and according to decel ramp time.
How to alter Parameters from keypad
1) To alter parameters:- Press the DISP/FUN key,
until the first parameter 00-00 is displayed.
2) Then use the arrow keys to select the parameter required then
Press READ / ENTER key to read the preset value.
3) Use the and < / RESET keys to alter the setting of the
parameters as per basic quick start parameter list.
Note:- For full parameter list refer to the instruction manual.
4) To save each parameter change, press READ / ENTER key then
the word END will be displayed.
5) Use key to select the next parameter to alter and
follow steps 2 to 4 until all changes are complete.
6) Pressing the DISP/FUN key repeatedly will alternate the display
between the preset frequency ( flashing display) and the last parameter
accessed or other selectable displays 0 to 7 when selected by parameter
12-00 according to the table below.
【0】:Disable display 【1】:output Current
【2】:output Voltage 【3】:DC bus voltage
【4】:Temperature 【5】:PID feedback
【6】:AI 1 .Value 【7】:AI2. Value