Page 3 of 10 11/07/14
Remote speed reference and Remote run
1) Ensure that you have carried out installation & wiring requirements as
per step1 quick start guide on previous page before you proceed.
2) For analogue signal type. -10V to +10V or 0-10V dc. Use the terminal
AI1 or AI2. Set SW2 in V position.
For analogue input type 4 -20mA. Use the terminal AI2. Set SW2 to I
Position. ( default).
. Connect remote potentiometer OR remote 0-10 vdc signal as required.
to terminals AI1 Or AI2.
Functions of AI1 & AI2 can be set by parameter 04-00 & 04-05.
Terminal + 12Vdc & -12Vdc is the supply provided for use with the
potentiometer.
Terminals AI1 &AI2 are for potentiometer wiper connection.
Terminal GND is 0Vdc.
3) Connect remote start switch if required according to diagram in the
instruction manual.
Use terminals +24Vdc & S1 (Forward run).
Use terminals +24Vdc & S2 (Reverse run)
Remote mode wiring. Speed reference and Run signals.
1) Power up.
Display will read the frequency from one of the following according to the
Connection made to AI1 or AI2 terminal. Set parameter 00-05 =0001
a) Remote external potentiometer
b) Remote 0-10VDC analog signal.
Check/ verify and alter parameters
Check / verify and alter parameters for remote start & remote frequency
as necessary before you proceed. Parameters 00-02 & 00=05
See quick start parameter list & How to alter parameters.
To Next Page
Loading...
