TECO A510 - Apply Power to the Drive; Test Run from Keypad; Alter Frequency from Keypad

Page 2 of 10 11/07/14
Apply power to the drive, the display will briefly show the supply voltage
220V followed by flashing.
This is the default ( factory set) frequency.
If the unit has been used previously then it will show the last frequency
programmed.
Step 2
Apply power to the drive
05.0
Step 3
Test run from keypad
Press RUN KEY to run.
The frequency will ram up to 5.0 Hz or the user pre-set frequency and
according to the default acceleration ramp time.
Press STOP key to stop.
The frequency will ramp down to zero according to the default decel ramp
time.
Step 4
To alter frequency from keypad. (Default setting).
Use the Arrow keys and
< /
RESET key
to alter the digits to the required frequency.
To store the set frequency use READ/ENTER Key
eg. 50.0 HZ then use
RUN
and
STOP
keys to start/ stop.