Need help?Do you have a question about the TECO N3 Series and is the answer not in the manual?
General| Model | N3 Series |
|---|---|
| Category | Inverter |
| Control Method | V/F Control, Sensorless Vector Control |
| Overload Capacity | 150% for 60 seconds, 200% for 3 seconds |
| Cooling Method | Forced Air Cooling |
| Altitude | Up to 1000m without derating |
| Power Range | 0.4kW to 630kW |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit, Phase loss |
| Braking Unit | Built-in |
| Communication | RS485, Modbus RTU |
| Operating Temperature | -10°C to +50°C |
| Humidity | 5% to 95% RH, non-condensing |
| Input Voltage | 200-240V, 380-480V |
| Storage Temperature | -20 to 60°C |
Precautions to take before applying power to the inverter for safe operation.
Safety and operational considerations when power is applied to the inverter.
Important checks and precautions before starting inverter operation.
Safety guidelines to follow while the inverter is actively operating the motor.
Instructions for connecting input and output power wires to terminal block TM1.
Table listing and describing each control terminal designation on block TM2.
Visual layout of control terminals TM2 and description of control switches.
Guidelines for wiring and connecting control signals to terminal TM2.
Procedure for accessing and setting basic (b) and advanced (A) parameters.
To Next Page