TECO N3 Series - 20.0 Option Modules and Cables

N3 Drive Operations Manual
Option Modules and Cables 82
20.0 Option Modules and Cables
The following Option Modules are available for the N3 Inverter series. They are easily installed and are inserted into
connector CON2 by removing the front cover.
!
CAUTION
When installing option modules, make sure that power has been removed from the
inverter and that the charge indicator is extinguished before proceeding.
Remove the front cover in accordance with the model being used (See Appendix D). After the option module has
been installed, replace the cover before powering-up the inverter. Do not operate the inverter with the cover
removed.
20.1 Option Module Part Numbers
Option Part Number
Description
*Keypad Remote Cable
Kit
FIG.
No.
Part Number
Length
Ft./ M
N3 – LED – W
Remote LED Keypad
SW305P
1.6 / 0.5
20.1.1
&
20.1.2
SW3001
3.3 / 1.0
*Select the desired cable length from table
SW3002
6.6 / 2.0
N3 – LCD – W
Remote LCD Keypad
SW3003
9.8 / 3.0
SW3005
16.4 / 5.0
SIF - 485
RS485 Interface
x
20.1.3
SIF - 232
RS232 Interface
x
20.1.4
SIF - MP
Copy Module
x
20.1.5
PDA Link
SIF - 232
RS232 Interface
x
20.1.6
1 – N3 Inverter (Frame 1 shown for reference)
2 – LED or LCD Keypad (Refer to Fig. 20.1.2 for mounting dimensions)
3 – Connecting cable (See table for cable kit number and length)
Fig. 20.1 Remote Keypad (LED or LCD)
Cont.