Need help?Do you have a question about the TECO E710-403-H3SF and is the answer not in the manual?
General| Model | E710-403-H3SF |
|---|---|
| Type | Inverter |
| Communication Protocol | Modbus RTU |
| Series | E710 |
| Frequency Range | 0-400Hz |
| Protection Level | IP20 |
| Cooling Method | Forced air cooling |
| Input Voltage | 3-phase 380-480V AC |
| Control Method | V/f Control |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit |
| Communication Interface | RS485 |
| Efficiency | 98% (typical) |
Safety guidelines before energizing the inverter, including wiring and handling.
Detailed instructions and warnings for inverter wiring procedures.
Precautions and checks before starting inverter operation.
Safe operating procedures and warnings during inverter use.
Procedures for maintaining, inspecting, and replacing inverter components.
Detailed listing and explanation of basic inverter parameters.
Parameters related to V/F control mode for motor operation.
Parameters controlling the inverter's start, stop, and fault handling behavior.
Parameters for various protection functions like stall and overload.
Parameters for motor auto-tuning procedures.
Overview of the inverter's fault detection and warning functions.
Detailed explanation of fault detection and restart procedures.
Explanation of warnings and self-diagnostic error codes displayed by the inverter.
General safety precautions related to electrical shock and fire hazards.
Explanation of motor overload protection settings and functionality.
To Next Page
