TECO A510 - Keypad Functions Overview

Page 5 of 10 11/07/14
Type
Name
Functions
Display
Main digital
displays
Frequency, parameter, voltage, current, temperature and
Fault message.
LED status display
FAULT: When the inverter has a warning or fault message,
the indicator lights up.
FWD: When the inverter is in forward run mode, the
indicator lights up.
RUN mode: Continuously ON.
Stop mode:- Flashes ON/OFF.
inverter stopping)
REV: When the inverter is in revere Run mode, the indicator
lights up.
RUN mode: Continuously ON.
Stop mode:- Flashes ON/OFF
SEQ: When Run command source is set to external control,
the indicator lights up.
REF: When Frequency command source is set to external
control, the indicator lights up.
Keys
（8 keys）
RUN
RUN: Run command at the set frequency.
STOP
STOP: Stop command. Decelerate or Coast to stop.
▲
Increments parameter number and preset values.
▼
Decrements parameter number and preset values.
FWD/REV
Sets Inverter speed and motor rotation direction.
DSP/FUN
Select between Frequency, Function ( parameters) and
Monitor displays according to the following sequence.
Frequency screen Function selectionMonitor
parameters Frequency screen.
</RESET
“<” is left shift key. It is used for changing parameter or
value.
RESET key：Use to reset Inverter resettable faults .
READ/ENTER
Used to display the preset value of parameters and for saving
the changed parameter values.