Page 7 of 10 11/07/14
Control Modes & Auto Tune
A510 provides five control modes
Select the relevant control mode for the application.
Default control mode is V/f.
V/f can be used for most applications specifically multi-motor
or applications where auto tune is not successful
or when a customized v/f pattern may be required.
Several V/f patterns are available selectable by parameter 01-00.
select the appropriate one based on the application load type and the motor base frequency of
50 or 60 Hz.
For selections of the V/f patterns . Refer to the instruction manual.
For Vector modes SLV & SV modes are used for obtaining best performance
from a motor and in applications that require dynamic response to torque and speed change
use SV + Encoder.
V/f Mode Parameters:-
F= General Purpose. 60 Hz. system
0= General Purpose . 50Hz. System
For full list of preset patterns set by 01-
00,refer to the manual.
FF= Customized V/f.
Set parameters 01-02 to 01-13.
For Motor1 parameters in V/f mode, set the name plate data in parameters 02-00 to 02-19
Parameters 02-09 to 02-19. Not normally need to be adjusted.
Note:- Two independent set of parameters can be set. Motor 1 & Mmotor2.
Parameters 02-20 to 02-26. ( Motor 2 can only function in V/f mode).
To Next Page
Loading...
