TECO JNEV-401~403-H3 - B. Run;Stop-Forward;Reverse Wiring Detail

Chapter 4 Software index
4-11
3.) Up/Down terminal: please refer to description of parameter group F11~ F15 (multi-function
input terminal).
4.) Priority of reading frequency command: Jog> preset frequency > (Keypad▲▼ or TM2 UP/
Down or communication)
F06 : External control operation mode 000: Forward/ Stop-Reverse/Stop
001: Run/ Stop-Forward/Reverse
002: 3-wire—Run/ Stop
1.) F06 is only available when F04 = 001 (external terminal).
2.) When both forward and reverse commands are ON, this will result in a stopped mode.
Note: In 3 wire control mode terminals S1-S3 are used, therefore parameters
F11~ F13 are ineffective.
(1). NPN input signal:
S1 (Forwar
d
/Stop)
S2 (Reverse/Stop)
COM (Common)
(2). PNP input signal:
Parameter F06 = 001, Control method is as follows:
(1). NPN input signal:
S1 (Run/Stop)
S2 (Forward / Reverse)
COM (Common)
(2). PNP input signal:
S1 (Run/Stop)
S2 (Forward / Reverse)
24V(Common)
Parameter F06 = 002, Control method is as follows:
(1). NPN input signal:
(2). PNP input signal:
S1 (Run)
S2 (Stop)
S3 (Forward/ reverse)
COM (Common)
S1 (Run)
S2 (Stop)
S3 (Forward/ Reverse)
24V (Common)
S1 (Forwar
d
/Stop)
S2 (Reverse/Stop)
24V(Common)
Parameter F06 = 000, Control method is as follows:
Figure 4-3a Fwd/stop-Reverse/Stop wiring detail
Figure 4-3b RUN/STOP-Forward/Reverse Wiring detail
Figure 4-3c 3-WIRE Run/Stop detail