Chapter 4 Software index
4-15
F11~F15=015 Master/Auxiliary speed switch
1) F05=001, when one of the parameters F11~ F15 is set to 015, and multi-function input
terminal is OFF, the frequency is set by the potentiometer on the Keypad(Master speed),
When the multi-function input terminal is ON, the frequency is set by the analog signal
on TM2 (Auxiliary speed AIN).
2.) F05=002, when one of the parameters F11~ F15 is set to 015, and multi-function input
terminal is OFF, the frequency is set by the analog signal on TM2,
(Master Auxiliary speed AIN); While multi-function input terminal is ON, the frequency
is set by the potentiometer on the Keypad (Auxiliary speed).
F11~F15=016 (PID function Disable)
When input terminal is on, PID functions set by C30 are disabled.
When input terminal is the PID functions are enabled.
F15=017 Analog frequency signal input (Terminal AIN)
Frequency reference can be set by 0-10Vdc or 4-20mA on terminal AIN as set by F16
and SW2.
F15=018 PID Feedback signal input (Terminal AIN)
PID feedback can be connected to AIN terminal 0-10Vdc/0~20mA or 2~10V/4-20mA as
set by F16 and SW2.
F11~F15=019 DC Brake signal
When TM2 DC Brake signal is OFF, and the brake time of F37 has not been over , then
brake time is according to set value of F37; When TM2 DC Brake signal is ON, and the
brake time of F37 has already been over , the brake is stopped according to DC Brake
signal OFF of TM2.
F16 AIN signal select
000: 0~10V/0~20mA
001: 2~10V/4~20mA
F16: AIN signal select: set SW2 to appropriate V/I signal selection
F16=000: 0~10V/0~20mA
F16=001: 2~10V/4~20mA
Run signal
Acceleration
/deceleration
prohibit
Output
frequency
※Note: Acceleration/deceleration prohibit is
unavailable if Run signal is OFF. (RAMP to stop)
Figure 4-6 Acceleration/Deceleration Prohibit
To Next Page
Loading...
