What to do if TECO Servo Drives shows CPU error?
If your TECO Servo Drive displays a CPU Error, it indicates a control system malfunction. Turn off the power and turn it on again after 30 minutes. If the error alarm persists, it may be due to external interference.
Why is my TECO JSDEP-15A Servo Drives disabled?
If your TECO Servo Drive is disabled, it means the input contacts CCWL & CWL are operated at the same time, causing this alarm. To solve this, remove the input contact signal CCWL or CWL. Then, check all input wiring for correct connections. For the selected High/Low logic potential settings refer to Section 5-6-1.
Why do TECO JSDEP-15A Servo Drives overheat?
If your TECO Servo Drive overheats, it means the power transistor temperature exceeds 90°C. Overload for a long duration will cause the driver to overheat. Check and reset the operation system.
General| Series | JSDEP |
|---|---|
| Model | JSDEP-15A |
| Rated Output Current | 15A |
| Applicable Motor Capacity | 1.5kW |
| Category | Servo Drives |
| Control Mode | Position, Speed, Torque |
| Feedback | Incremental Encoder, Absolute Encoder |
| Input Voltage | 200~230VAC |
| Communication Interface | RS-485 |
| Protection Features | Overcurrent, Overvoltage |
To Next Page
