L510s EMC Ferrite Core Installation
In order to comply with EMC requirements, install the supplied ferrite cores
as shown below :
Suitable for 2P2/2P5/201 (frame 1 models)
Single phase , 220V input
Connect to L1(L)&L3(N)
Power cable should be
wound three times through
the ferrite cores
Suitable for 202/203 (frame 2 models)
Ground terminal
Single phase , 220V input
Connect to L1(L)&L3(N)
Power cable should be wound two
times through the ferrite core
Ground cable should be wound three
times through the ferrite core
To Next Page
Loading...
