TECO L510s User Manual

Page 1 of 9 06/10/17
TECO L510s Inverter
Quick Start Guide
1) Ensure that the Inverter & the motor have the correct
KW power and voltage ratings.
Motor full load amps must not exceed the Inverter rating.
2) Ensure that the supply & Motor cables are connected
correctly prior to power up.
3) For single phase supply, use L1(L) & L3(N) on units which
have 3 supply terminals.
4) Connect motor cable to terminals T1, T2 &T3.
(Swap two leads if motor runs in reverse direction).
5) Connect supply Earth and the motor Earth to the drive Earth
terminal.
Note:-
I ) For detailed installation
and wiring refer to the
Instruction manual.
This guide is to assist you in installing and running the inverter and verify that it is
functioning correctly for it’s main and basic features.
For detailed information and if there are any doubts please refer to the instruction manual.
Step 1
Supply & Motor connection

TECO L510s Specifications

General

Brand	TECO
Model	L510s
Category	Inverter
Language	English

Summary

Quick Start Guide

Step 1 Supply & Motor connection

Guide to connecting power supply and motor to the inverter.

Step 2 Apply power to the drive

Instructions for applying power to the inverter and checking the display.

Step 3 Test run from keypad

How to perform a test run using the inverter's keypad controls.

Step 4 To alter frequency from keypad

Procedure for changing the operating frequency via the keypad.

Remote speed reference and Remote run

Step 1 Remote mode wiring. Speed reference

Wiring requirements for remote speed reference signals like potentiometers or 0-10V.

Step 2 Remote mode Run

How to connect switches for remote start/stop operation.

Step 3 Check/ verify and alter parameters

Verifying and adjusting parameters for remote operation.

Step 4 RUN using remote speed reference

Running the inverter with remote speed reference signals.

How to alter parameters using the keypad

Basic Quick Start Parameter List

Control Modes & Auto Tune

V/f Mode Parameters

Parameters available for selecting V/f patterns based on application.

SLV (vector) mode set parameters

Setting motor parameters for SLV (vector) mode and enabling auto tune.

Standard wiring

Single phase (PNP input) Frames 1&2

Standard wiring diagram for single phase PNP input inverters.

400V Three phase (PNP input) Frame 2

Three phase (PNP input). Frames 3&4