TECO L510s - Step 2 Apply power to the drive; Step 3 Test run from keypad; Step 4 To alter frequency from keypad

Page 2 of 9 06/10/17
Apply power to the drive, the display will briefly show the supply voltage
220V followed by flashing.
This is the default (factory set) frequency.
If the unit has been used previously then it will show the last frequency
programmed.
Step 2
Apply power to the drive
5.00
Step 3
Test run from keypad
Press RUN KEY to run.
The frequency will ramp up to 5.0 Hz or the user pre-set frequency and
according to the default acceleration ramp time.
Press STOP key to stop.
The frequency will ramp down to zero according to the default decel ramp
time.
Step 4
To alter frequency from keypad. (Default setting).
Use the Arrow keys and
< /
ENT
To alter the digits to the required frequency.
eg. 50.0 HZ then use RUN and STOP keys to start / stop.