45
Fn_51: Display Mode Selection 1 ~ 5
The Display contents can be switched back and forth using the key either in the run
mode or stop mode.
Frequency/ RPM / Line speed (Mode set by (Fn_51)
Fxxx (Parameters setting mode: refer to digital operator illustration)
Output voltage DC voltage (Output voltage, DC voltage
(Output current), power set-up at
(Fn_47)
Output current
Fn_52: Line Speed Display 1 ~ 0-9999
120 freq.
(RPM) = x frequency ; Line speed = xFn_52 (decimal digits
Fn_36 Fn_06 decided by Fn_51)
Fn_53: DC Braking Time 0.1 ~ 0 to 25.5 Sec.
Fn_54: DC Braking Injection Frequency 0.1 ~ 0.1 to 10 Hz
Fn_55: DC Braking level 0.1 % ~ 0 to 20 %
Fn_56 ~ Fn_58: Multifunction Inputs
Note:
The application parameters in the Multifunction Input list are all assignable on TM2.
Terminals (6) (7) and (8) are the designated application terminals for the following features.
DSN
FUN
To Next Page
Loading...
