7
PRE WASH CHECKLIST
Before starting each wash, please check the following:
Level the clothes washer by adjusting the feet.
Install the water inlet hose
Connect to a power source
Adjust the feet by turning clockwise
to extend or anti clockwise to
shorten.
Slightly tilt the clothes washer back
to access the adjustable feet.
Ensure all four corners are fl at and
level to the surface it is placed on.
Ensure the clothes washer is
level and stable prior to starting
each wash. An unstable clothes
washer can cause the drum to
shake during a wash and knock the
cabinet.
Ensure the inlet hose has been
correctly installed and is securely
fastened to the water mains and
the inlet valve at the rear of the
clothes washer.
Ensure the inlet hose has been
attached to a COLD water tap only.
NOTE: Ensure your hands are
completely dry before touching the
mains outlet, any electrical plugs or
cables.
Ensure the clothes washer is securely plugged
into the mains power supply and it is switched to
the ON position.
Adjustable feet
CAUTION
To Next Page
Loading...
