TECORP ELECTRONIC HC2-E1000 Series - Page 15

HC2-E1000 SERIES
- 14 -
Code Parameter Settings Default
F120 Jog frequency 0.0 ~ 10.0Hz 0.2Hz *2Hz
F121 Jog acceleration time 0.01s ~ 60.00s 1s
F2 group – Input / Output parameters
Code Parameter Settings Default
F200 Control mode
0: General
1: Knitting
0
F201 X1 terminal
1: Speed terminal 1
2: Speed terminal 2
3: Speed terminal 3
14: Instant stop
(normal open)
15: Instant stop
(normal close)
1
F202 X2 terminal 2
F203 X3 terminal 3 *16
F204 X4 terminal 4: Jog 4 *0
F216 Multi-speed frequency 1
0.0 ~ 400.0Hz
5Hz
F220 Multi-speed frequency 2 10Hz
F224 Multi-speed frequency 3 15Hz
F228 Multi-speed frequency 4 20Hz
F232 Multi-speed frequency 5 30Hz
F236 Multi-speed frequency 6 40Hz
F240 Multi-speed frequency 7 50Hz
F3 group – Advanced parameters
Code Parameter Settings Default
F301
Carrier frequency
adjustment
0.0 ~ 12KHz
6KHz
*7KHz
F306 Reverse mode 0: enable 1: disable 0
F320 Unlock parameters
0: All parameters unlocked
2: Only this group unlocked
F321
Initialization
parameters
0: No action
1: Clear fault records