TECshow Cubex 360 - Software Version

CUBEX 360
P.
10
ENGLISH VERSION
1. Press Enter into Gren.
2. Press Up/Down, Choose ‘000~255’
3. Press Enter to confirm, or press “MENU” to exit.
Blue
1. Press Enter into Blue.
2. Press Up/Down choose ‘000~255’
3. Press Enter to confirm, or press “MENU” to exit.
White
1. Press Enter into Whit.
2. Press Up/Down choose ‘000~255’
3. Press <Enter> to confirm, or press “MENU” to exit.
Strobe
1. Press Enter into Stro.
2. Press Up/Down choose ‘000~255’
3. Press Enter to confirm, or press “MENU” to exit.
Dimmer
1. Press Enter into Dim.
2. Press Up/Down choose ‘000~255’
3. Press Enter to confirm, or press “MENU” to exit.
LED
1. Press Enter into led.
2. Press Up/Down choose ‘000~255’
3. Press Enter to confirm, or press “MENU” to exit.
LED setting
1. Press MENU to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER
to enter LED.
3. Press Up/Down to choose ‘ON’/‘OFF’
4. Press Enter to confirm, or press “MENU” to exit.
Display reverse setting
1. Press MENU to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER
to enter Disp.
3. Press Up/Down to choose ‘ON’/‘OFF’
4. Press Enter to confirm, or press “MENU” to exit.
Whole test
1. Press ENTER to enter EDIT interface
2. Press UP/DOWN, then press ENTER Test to do whole test
3. Press Enter to confirm, or press “MENU” to exit.
Operate time
1. Press ENTER to enter EDIT interface
2. Press UP/DOWN, then press ENTER Fhrs
to check the light’s working time
3. Press Enter to confirm, or press “MENU” to exit.
Soware Version
1. Press ENTER to enter EDIT interface
2. Press UP/DOWN, then press ENTER Ver to
check the light’s version information
3. Press Enter to confirm, or press “MENU” to exit.
Whole reset
1. Press MENU to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER
to enter Rest.
3. Aer reset, it will go back to the upper interface
Restore factory settings
1. Press MENU to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER
to enter Defa.
3. Press Enter to confirm,or press “MENU” to exit.