TECshow NAVIGATOR 24 MKII User Manual

P. 9
| Tecshow Navigator 24 MKII
4. Press and hold down the Edit button.
5. While holding down the Edit button, tap the
Flash button that corresponds to the program
you wish to edit.
6. Release the Edit button, the relevant scene
LED should light indicating you are in the Edit
mode.
Erase a Program
1. Record enable.
2. Use the Page button to select the page the
program you wish to erase is on.
3. While holding down the Edit button, tap the
Flash button (13-24).
4. Release the two buttons, all LEDs ash, indicat-
ing the program is erased.
Erase All Programs
1. Press and hold the Record button.
2. Tap the Flash buttons 1, 4, 2 and 3 in sequence
while holding the Record button. All LEDs will
ash, indicating all programs stored in memory
have been erased.
Clear a Scene or Scenes
1. Record enable.
2. Record a scene or scenes.
English version

TECshow NAVIGATOR 24 MKII Specifications

General

Brand	TECshow
Model	NAVIGATOR 24 MKII
Category	Controller
Language	English