[2] TURN ON/OFF LW
To turn ON/OFF LW press & hold the [2] button until “
LW
ON”
or “
LW
OFF” appears on the display.
[3] MW (AM) 9K/10K TUNING STEPS
To select your desired AM tuning steps press & hold the [3]
button until “9kHz” or “10kHz” appears on the display.
[4] BATTERY LOW VOLTAGE SHUTDOWN LIMIT
Press & hold the [4] button until the current low battery limit
is displayed. Use the TUNING knob to adjust the low bat-
tery limit between 3.4 – 3.7 volts. Press [4] again to save.
[5] LCD BACKLIGHT ON/OFF
Select the OFF position on the LCD Back light switch then
press & hold the [5] button to toggle the display between
“ON” and “OFF”. If OFF the display light will not turn on
when you flip the light switch on the side of the radio to ON.
[8] ADDING SECONDS TO THE TIME DISPLAY
Press & hold the [8] button until seconds appear on the
clock display..
[AM BW] LCD TEST / FIRMWARE VERSION
Press & hold the [AM BW] button until all the LCD elements
turn on. Pressing [AM BW] again will display the firmware
version (Latest version is 8820). In some receivers pressing
[AM BW] a third time displays the manufacture date.
[VF/VM] RUN TIME SINCE BATTERY CHARGE/RESET
Press & hold the [VF/VM] button until the amount of time the
radio has ran since the last battery charge or the last time
the receiver was reset is shown.
[VF/VM] DAYS SINCE FIRST POWER ON
Press & hold the [VF/VM] button until the Run Time appears
Before the RunTime display clears press the [VF/VM] button
again. The number in the upper right is the number of days
since the radio was new and the battery was first installed.
A time in the format XX.xx also appears where xx is in
seconds.. At this time the purpose of this number is
unknown.
To Next Page
Loading...
Need help?
General
