40
10
327
LOCK
ACTUAL
M3
M
Yd
MODE: SLOPE
VIBRATION
USE SLOPE MODE TO OBTAIN THE DISTANCE TO THE CLOSEST OBJECT.
THIS MODE IS ALSO KNOWN AS THE "CLOSEST DISTANCE OBJECT
PRIORITY FUNCTION".
+
1. SLIDE THE SLOPE SWITCH ON
AND YOU WILL SEE THE ANGLE
SYMBOL AND THE FLAG SYMBOL
ON THE SCREEN AS AN INDICATOR.
2. PRESS THE POWER BUTTON AND
AIM AT THE TARGET WHOSE DIS-
TANCE YOU WANT TO CALCULATE.
3. NEXT TO THE YD SYMBOL WILL BE
THE DISTANCE IN YARDS. THE ANGLE
OF THE SLOPE WILL APPEAR. THE WORD
"ACTUAL" WILL BE THE SLOPE CORRECTED.
NOTE: THE SLOPE FACEPLATE MUST BE PULLED OUT INTO POSITION TO
USE THIS MODE. WHEN MEASURING BE SURE TO HAVE NO OTHER
OBJECT BETWEEN YOU AND YOUR TARGET.
MODE: PIN SEEK
VIBRATION
117
LOCK
SCAN
M2
Yd
USE PIN SEEKER MODE TO FIND THE CLOSEST VERTICAL OBJECT SUCH AS
THE DISTANCE TO A FLAGSTICK ON A GREEN WITH WOODS IN THE BACK-
GROUND; AS WELL AS WHEN MEASURING OVERLAPPING TARGETS.
+
1. PRESS THE MODE BUTTON BRIEFLY
TO SEE A FLAG ICON ON THE DISPLAY
WHICH INDICATES THAT YOU ARE IN
PIN SEEKER MODE.
2. TARGET AN OBJECT BEHIND THE
FLAG. PRESS AND HOLD THE
POWER BUTTON WHILE SLOWLY
SWEEPING OVER THE FLAG..
3. THE RANGEFINDER WILL LOCK ONTO
THE NEAREST TARGET (I,E, THE FLAG)
AND DISPLAY THE DISTANCE.
NOTE: IT IS IMPORTANT NOT TO PAN TOO FAR BECAUSE THE RANGEFINDER
MAY "LOCK" ONTO AN OBJECT IN THE CLOSEST DISTANCE THAT IS NOT
YOUR INTENDED TARGET.
To Next Page
Loading...
Need help?
General
