C OPERATION WITH THE CONTROL PANEL
A = Temperature / time indicator
B = Function indicator
C = On / off button
D = Water reservoir full
E = Remote contr
ol sensor
Insert the plug into the socket.
Before switching on the airconditioner first always open the air outlet flap by
pressing on both markings on the air outlet flap.
Press the button on the control panel on the front of the airconditioner to
switch the machine on. Using the button on the machine to switch the
airconditioner on will start it in the automatic mode. The machine will use
values set in the factor
y to automatically deter
mine whether the active mode
is cooling, ventilator or dehumidifier
. The ventilator speed will also be
deter
mined automatically
. Use the r
emote contr
ol
P supplied to change the
automatic mode (r
efer to chapter D).
G
COMMENTS
The airconditioner will not function effectively if the air outlet flap is
closed. Failing to open the outlet flap correctly can significantly reduce
the life span of the airconditioner. Damage caused by failure to open
the air outlet flap is not covered by the guarantee.
G
ATTENTION!
Ensure that the remote control does not become wet. Remove it from
the machine if there is a risk of it becoming wet.
G
I
MPORTANT
The flexible exhaust hose should be less than 1m during operation,
w
hich provides the best performance. This length has been designed
especially according to the specifications of the air conditioner. Do not
use an extension or exchange for a different hose as that may lead to
malfunctioning. The exhaust air must flow freely, any blockage can lead
to overheating of the air conditioner. Take care to prevent any bow or
bend in the exhaust hose.
4
68
A B C D E
man_TP020_1 09-02-2007 12:04 Pagina 68
To Next Page
Loading...
