To Next PageTo Next Page
Need help?Do you have a question about the teel 3P683D and is the answer not in the manual?
Explains safety alert symbol, DANGER, WARNING, and CAUTION to identify potential hazards.
Provides crucial safety advice for operating and maintaining the pump.
Details hazards of capacitor voltage and safe discharge procedures.
Instructions for correct motor wiring, grounding, and voltage conversion.
Outlines the one-year limited warranty coverage for Teel pumps and systems.
Covers limitations of liability, warranty disclaimers, and product suitability.
Explains the process for prompt disposition of defective products under warranty.
Steps for removing an old pump before installing the new Teel pump.
Detailed instructions for installing the pump in driven point well systems.
Guidance for installing the pump into cased wells, including pipe connections.
Details on suction pipe joints, fittings, and slope for well point installations.
Instructions for installing the pump when using surface water sources like cisterns.
Connecting the pump to a pre-charged tank, including pre-charge adjustment.
Steps for connecting a standard tank and its air volume control (AVC).
Guides for converting the pump motor between 230V and 115V operation.
Detailed instructions for connecting motor wires to the pressure switch.
Important warnings regarding hazardous voltage, grounding, and branch circuits.
Step-by-step guide for connecting ground wires and power supply for safe operation.
Provides recommended wire sizes and fuse ratings based on motor HP and distance.
Instructions on priming the pump and piping for initial startup and operation.
Steps to protect the pump and tank from freezing during winter.
Procedures for draining and preparing pre-charge and standard tanks for winter.
Instructions for safely disconnecting power and draining the pump before disassembly.
Steps to remove the motor, seal plate, impeller, and ejector components.
Guide for cleaning or replacing the pump impeller and shallow well ejector parts.
Procedure for removing the old shaft seal from the pump.
Steps to remove the seal plate and the stationary half of the shaft seal.
Guide on cleaning the cavity and installing the stationary ceramic seal half.
Lubricating and sliding the rotating seal member onto the shaft correctly.
Details on correctly locating and mounting the diffuser onto the seal plate.
Instructions for lubricating the O-ring and securely mounting the motor back onto the pump body.
Explains the cycle of air and water within the tank for Model 3P715B.
Procedure to test the tank bladder for leakage by draining and checking.
Steps for safely removing the tank cover and cutting out the old bladder.
Guide for rolling and properly inserting the new bladder into the tank.
Instructions for seating the tank head and tightening nuts to ensure a proper seal.
How to check and adjust the air pressure in the tank for optimal performance.
Provides contact details for ordering replacement pump parts.
Lists part numbers and descriptions for pump components with reference illustrations.
Illustrates the components of the tank assembly for Model 3P715B.
Lists part numbers and descriptions for the Model 3P715B tank.
Diagnosing motor faults, lack of water delivery, and low capacity issues.
Troubleshooting pressure switch adjustments and pump not shutting off.
Steps to diagnose and resolve frequent pump on/off cycling.
Guidance on identifying and fixing the cause of air spurts from faucets.
General| Model | 3P683D |
|---|---|
| Category | Water Pump |
| Brand | Teel |
| Power Source | Electric |
| Housing Material | Cast Iron |
| Impeller Material | Bronze |
| Type | Centrifugal |
| Seal Type | Mechanical Seal |
