TABLE MAT: TIGHTENING
• If you feel the nylon mat needs to be tightened, pull the adjustment straps
on the back of the mat.
Assembly Instructions #IIL202 Pg. 4
Figure 9
STORING THE INVERSION TABLE
IMPORTANT NOTE: The F9000
TM
will not fold for storage while in Setting “C”
of the roller hinge. You must have the roller hinge set in either the “A” or “B”
setting to do so.
• Loosen the de-rattler knob.
• Pull the height selector locking pin and slide the main shaft in all the way
to the ankle clamp assembly. Engage the pin in the storage setting.
• Rotate the table opposite from use until the table has turned 180 degrees
and rests against the cross bar on the A-frame.
• The legs of the A-frame base may then be folded together for compact
storage. (See figure 9). WARNING: This operation may pinch fingers if
not done slowly and carefully.
For information about the Teeter Hang Ups
®
5-year warranty, or if you have any problems
assembling the equipment or questions about its use, please contact Customer Service at the
appropriate location below:
U.S. and foreign patents apply. Other foreign patents pending.
Teeter Hang Ups
®
is a registered trademark of STL International, Inc.
and Inversion International, Ltd.
Specifications subject to change without notice.
© COPYRIGHT 2004, Inversion International, Inc.
International Law Prohibits Any Copying, 11/04
* any modification to this device
will void the UL Classification
Classified as Medical
Equipment, part I in accordance
with UL 2601-1 and CAN/CSA
C22.2; General Requirements
for Safety in accordance with
Underwriters Laboratories, Inc.
TABLE MAT: REMOVING / CLEANING
• You may find it easier to remove the nylon mat while the table is in its
storage position.
• Pull up on the plastic tension clips to loosen the adjustment straps.
• Release one corner at a time, then slide the mat off the frame.
• The mat should be washed in cold on gentle cycle. Replace the mat on
the table frame while still wet.
• To tighten the nylon mat, pull the adjustment straps on the back of the
mat.
ASSEMBLY
USA & Canada:
STL International, Inc.
9902 162
nd
St. Ct. E., Puyallup, WA 98375
Toll Free (Phone) 800-847-0143 (Fax) 800-847-0188
Local (Phone) 253-840-5252 (Fax) 253-840-5757
(email) Info26@STLIntl.com (web) www.STLIntl.com
International:
Inversion International, Ltd.
PO Box: AP 59245, New Providence Island, Bahamas
(Phone) +1-242-362-1001 (Fax) +1-242-362-1002
(email) Info@InversionInternational.com (web) www.InversionInternational.com
European Distributor:
Teeter Ltd.
Cygnet House, Sydenham Road, Croydon Surrey, CR0 2EE, United Kingdom
(Phone) +44-20-8667-0060 (Fax) +44-20-8680-3999
(email) mail@teeterltd.com (web) www.TeeterLtd.com
Authorized Representative according to MDD 93/42/EEC MDSS
MurckhardstraBe1, 30163 Hannover, Germany
To Previous Page
Loading...
