F71002
ITEMS FOR ASSEMBLY ITEM #’s
A-frame base F71002
w/ EZ-Angle Tether Strap F51008
Main shaft w/ ankle clamp F91039
Table frame with mat F51021
Hand grips (2) and F51069
13 mm
(1/2”) hex bolts (6) H11202
Two (2) roller hinges F51064
Two (2) wrenches F51088
F91039
F51021
Bolts may be
packaged
separately or
assembled in
hand grips.
H11202
F51069
F51064
F51088
ASSEMBLY INSTRUCTIONS
DO NOT DISCARD - KEEP FOR FUTURE REFERENCE.
ASSEMBLY
Figure 2
(L)
(R)
NOTE: Bolts may be
packaged separately
or assembled in
hand grips.
U.S. and foreign patents apply. Other foreign patents pending.
Figure 1
Spreader Arms
front rear
1. It is your responsibility to familiarize yourself with the proper use of the equipment and the inherent risks of inversion, such as
falling on your head or neck, pinching, entrapment or equipment failure.
2. This product is not designed for persons over 198 cm (6’6”) or 136 kg (300 lbs). Structural failure could occur or head/neck may
impact floor during inversion. Serious injury or death could result.
3.
DO NOT use this equipment without a licensed physician’s approval and a review of the medical contraindications, as noted in
the Owner’s Manual.
4. Failure to assemble and/or use the equipment as directed may void the manufacturer’s warranty on this product and could result
in injury or death.
5.
DO NOT use the inversion table until you have thoroughly and carefully read the Owner’s Manual, viewed the Instructional Video,
reviewed all other accompanying documents, and inspected the equipment. The Instructional Video is in English. The steps in
the video directly coincide with the steps detailed in these Assembly Instructions.
6. Choose a level surface for assembling and operating the table.
7. Follow each step in sequence. Do not skip ahead.
8. Make sure that all fasteners are secure.
9.
PRIOR TO USE, test and inspect the table. Make sure the table rotates smoothly to inverted position and back.
10. Replace defective components immediately and/ore keep the equipment out of use until repair.
STEP ONE
Assemble the A-frame Base (F71002)
• Open the A-frame and make sure that the spreader arms are locked flat. (See
Figure 1)
STEP TWO
Install Hand Grips (F51069) on A-frame Base (F71002)
• Place one of each hand grip (left / right) over the outside edge of the corre-
sponding hinge plate. (See Figure 2)
• Insert three 13 mm (1/2”) hex bolts (H11202) through the hinge plate into each
hand grip. Use the wrenches provided to tighten the bolts, being careful not to
over tighten.
Carefully remove the individual parts from the carton. You should have all of the items listed below. If any items are missing or
damaged, contact your retailer or customer service directly (See Pg. 4).
Before you begin: These instructions will guide you in properly assembling the unit. Please review all the steps before beginning
assembly. Carefully adhere to the Assembly Instructions and Owner’s Manual to help ensure user safety and product integrity.
PRE-ASSEMBLY
WARNING
!
F9000
TM
F51008
To Next Page
Need help?
General
