Teeter EP-560 - Customization and Care

Secure When Not in Use
If left in the in-use position (unfolded), you can prevent unintentional
rotation by either looping the Angle Tether around the Main Shaft
and Crossbar then attaching it to itself with the clip (Figure 19) or
securing with a Key Lock (available at teeter.com). Test to ensure the
inversion table cannot rotate.
Fold for Storage
Your EP-560 easily folds for compact storage in seconds
and stands in an upright position.
Disconnect the Angle Tether. Slide the Main Shaft in and lock the
Height-Selector Locking Pin into the last hole. Rotate the backrest
forward (the opposite of inversion) until it rests on the Crossbar.
Fold the A-frame, leaving it slightly open for upright stability
(Figure 20). If there are children or animals in the house, lay flat
on the floor for storage.
Maintain Your EP-560
Wipe with a damp cloth to clean. Prior to every use, check for wear
and tear. Replace damaged or worn parts immediately. Keep out of
service until repaired. Contact Teeter for service recommendations.
WARNING
!
Tipping Hazard: Leave A-Frame open wide enough to remain stable, or secure
to a wall to prevent tipping. If children are present, store flat on floor, not
upright, and secure to prevent unintentional rotation.
9
Figure 19
Figure 20
Customize Your Relief
Lumbar Bridge
An optional accessory to add deeper decompression and alignment
benefits, simply insert the notches of the Lumbar Bridge into the
slots of the Table Bed and adjust the height and position to fit
comfortably at the small of your back (Figure 17).
Acupressure Nodes
Relieve muscle tension by placing the optional Acupressure Nodes
in the slots of the Table Bed that best align with your targeted area
(Figure 18). Start with smallest and work your way up to taller nodes.
For more about these Accessories, refer to the Assembly & User Instructions.
Personalize the intensity and target zone by experimenting with the height
and placement of the accessories. You may discover that you prefer one
or both, or opt to not use at all. It's about finding what feels good and
achieving the results you desire.
Figure 17
Figure 18