TEFAL Cake Factory Infinity - Using Moulds and Accessories; Non-stick Aluminium Mould Usage; Steel Moulds Usage; After Cooking Mould Handling

Using moulds and accessories
To ensure the proper operation of your appliance, when filling the moulds, do not exceed the
proportions indicated.
Non-stick aluminium mould
Grease the mould Fill the mould Ensure that the
black reflector is
properly in place
and attached to
the bottom of the
appliance
Insert the mould Close the appliance
Steel moulds
Fill the moulds 3/4 full.
Pour the mix into
the steel moulds
Place the moulds
into the holder
Put the holder into
the appliance
Close the appliance
After cooking
Allow to cool for a
few minutes before
removing from the
moulds.
Wear oven gloves
when removing the
holder from the
CakeFactory
Place the holder
on a heatproof
surface
Remove the moulds
from the holder one
at a time
You can mix the different moulds, using the same recipe and the same quantity for each mould.
Description
7
1
8
3
4
6
10
9
2
5
12
11
1 Lid
2 Control panel
3 Appliance base
4 Non-stick aluminium mould
5 Tart mould
6 Baking tray
7 Non-stick steel muffin moulds (x9)
8 Power cable
9 Black reflector
10 Holder for 9 individual moulds
11 Glass pots + plastic lids (x9)
12 Lid open/close handles
1918
en en