TEFAL SV6140G0 User Manual

28
Problem Possible Causes Solutions
Water streaks
appear on
the linen.
Your ironing board is
saturated with water
because it is not
suitable for use with
an appliance.
Check that your ironing
board is suitable. We
recommend that you
use a vented/mesh
type ironing board.
Brown streaks
come through
the holes in
the soleplate
and stain the
linen.
You are using
chemical descaling
agents or additives in
the water ironing.
Never add this type of
product in the water
tank (see “for what
water may be used”).
Contact an Approved
Service Centre.
The soleplate
is dirty or
brown and
may stain the
linen.
You are ironing at too
high a temperature.
See our
recommendations
regarding temperature
control setting.
The “anti calc”
indicator is
ashing*.
The anti calc
cartridge is no longer
ecient.
Replace the anti scale
cartridge with a new
one then press the
reset button for a
minimum of 3 seconds.
The descaling
procedure must be
performed.
See section "Descaling
your generator." In this
manual to perform the
descaling procedure.
Problem Possible Causes Solutions
The anti calc
indicator
is still
ashing after
replacing the
cartridge.
You have not pressed
the reset button.
Press the reset button
until the light stops
ashing.
The anti calc
indicator
is still
ashing after
performing
the descaling
procedure.
The descaling
procedure has not
been correctly done.
See section "descaling
your generator".
* Depending on the model
If you have any problems or queries please call our Customer
Relations team rst for expert help and advice

TEFAL SV6140G0 Specifications

General

Brand	TEFAL
Model	SV6140G0
Category	Iron
Language	English