Tefcold UFFS370SD - User Manual

Operating Instructions for Upright Freezers
Model UFFS370SD & UFSC370SD with a solid insulated door & UFFS370G & UFSC370G with a
heated glass door.
Congratulations with your new freezer. We feel certain that it will be very useful to
you for many years ahead.
To obtain optimal benefit from your freezer, please read the following instructions
thoroughly and act accordingly.
1. INSTALLATION
A1. Check whether the freezer has been damaged during transportation.
If yes, contact your dealer immediately.
A2. Place the freezer on a plane surface and level it by means of the two
adjustable feet under the front of the cabinet. Use a spirit level. The
freezer can be built in if you leave a free space of min. 50mm over the cabinet.
A3. Do not place the freezer close to strongly heat-emitting sources, and
do not expose it to extensive sunlight.
A glass door freezer must never be place in direct sunlight.
A4. Note that the ultra-violet rays of the sun can affect goods stored in
Freezer with see-thru door.
A5. The freezer is equipped with a condenser on the rear side and we
recommend to have the condenser cleaned with a soft brush each
second month.
A6. To minimize operating costs and maximize the life time of the compressor
it is essential to allow a good ventilation of the rear condenser.
A7. The freezer has been cleaned from the factory but we recommend you to clean
It again using a solution of one teaspoon of sodium bicarbonate to 0.5 litre
hot water.
Do not clean the glass door with powder or scrubbing detergents
2. ELECTRICAL CONNECTION
This freezer is equipped with a non-rewire able plug. If the plug does not fit with the
socket, you have to call the service or appointed skilled people
This installation of a new plug may only be made by skilled persons.
WARNING: This freezer must be earthed.
Plug the mains lead into a socket, which will supply the voltage, indicated on the rating plate.
Europe usually 230V/50Hz. Variations in the mains voltage of +/- 10% are allowed, but major
variations will reduce the life time of the compressor.
If there is any doubt about the correctness of the installation, we recommend that a
qualified electrician, who can assure that the freezer, is operating satisfactorily and
that it has not been damaged in transit should check it.
If the supply cord is damaged it should be replaced by the manufacturer or appointed
service agent in order to avoid a hazard.
Our freezers are made from first-class material comply with IEC requirements.
1

Summary

Installation Guide

Installation Procedures

Guidelines for positioning, leveling, ventilation, and initial cleaning of the freezer.

Electrical Connection and Safety

Electrical Connection

Instructions for connecting the power supply, including warnings about plugs and earthing.

Control Panel Overview

Control Panel Components

Description of the main components of the control panel, including lamps and knobs.

Using the Freezer

Operational Guidelines

Recommendations for initial cleaning, temperature adjustment, and food placement for optimal operation.

Frozen Food Storage

Defrosting Procedure

Defrosting Steps

Step-by-step instructions for safely defrosting the freezer and its shelves.

Troubleshooting Guide

Troubleshooting Checks

A series of checks to identify and resolve common operational disturbances.

Loading of Freezing Shelves

Technical Data Specifications

Tefcold UFFS370SD Specifications

General

Model	UFFS370SD
Category	Freezer
Type	Upright Freezer
Capacity	370 L
Gross Volume	370 L
Climate Class	SN-T
Refrigerant	R600a
Voltage	220-240 V
Frequency	50 Hz
Width	60 cm
Height	185 cm
Feet	Adjustable
Castors	No
Lock	Yes
Light	LED
Defrost	Manual
Reversible Door	No
Finish	White
Number of Doors	1
Noise Level	42 dB
Color	White
Number of Shelves	4
Shelf Material	Wire