Tegam 1830A - Page 47

10 TEGAM WAY • GENEVA, OHIO 44041 440-466-6100 • FAX 440-466-6110 • www.tegam.com
4-31
Section IV– Operating Instructions
Error Code
Description
The passed sensor serial number length is too long. The
maximum length is 18 characters
30
Invalid Value
A passed value is invalid
31
Duplicate Record
Another record with these values already exists
32
No Record
No record was found with the requested values
33
User Not Administrator
An operation was attempted that can only be done by an
administrator
34
User Already Logged In
Another user is already logged in
35
Serial Port Time Out
Communications on the serial port timed out
36
DEBUG ERROR
37
Invalid menu keypress
38
Cannot Set IP address
39
Programming Failure
40
There are active errors and return value may not be
valid
41
Invalid Data
42
Invalid Trigger Variable
43
Unbalanced Voltage
44
Voltage Error
45
Power Under Load
46
Power Over Load
47
Error while in calibration state
48
System in Standby
49
System is zeroing
50
Lock Failed
51
Fork Failed
52
Fork Application Failed
53
Bad File
54
Invalid calibration
55
OWD Check in Process
Table 4-5 - Error Codes