TEST VOLTAGE Jack is recessed to prevent any accidental
encounter.
Three Binding Posts for connection of test leads are marked
SIG (Signal), GUARD and GND (Ground). Proper connections
to the resistor under test are described in Section 2.2 below.
WARNING
DO NOT TOUCH THE BINDING POSTS WHEN THEY ARE
CONNECTED TO EXTERNAL CIRCUITS. LETHAL
VOLTAGES MAY BE PRESENT AT THESE POSTS.
1.4 List of Items Furnished
1 each Model R1M-A with power cord
2 each test cables, one shielded with two alligator clips
and the other with one alligator clip
1 each R1M-A Instruction Manual
1.5 Storage and Shipping Requirements
Standard precautions which apply to electronic test
instruments should be followed. A hard mechanical
shock, such as from dropping the R1M-A, could damage
the liquid crystal display. Care should be taken to
prevent damage to associated cables.
The R1M-A should be stored in a relatively dust-free
environment.
Temperature: -40 °C to +71 °C.
Relative humidity: 0 to 100%, non-condensing.
Altitude: 4570 m
See Section 5.7 below for shipping requirements.
To Next Page
Loading...
