Teka CLC - Cleaning and Maintenance Procedures; Cleaning the Coffee Grounds Container; Cleaning the Drip Tray

14
• Waitafewminutesforthecappuccinomaker
to cool down, then holding the cappuccino
maker lever firmly in one hand, unscrew the
cappuccino maker itself with the other, tur-
ning it clockwise and removing it downwards
(fig. 20).
• Removethecappuccinomakernozzle(A11)
by pulling it downwards (fig. 21).
• Washthecappuccinomakerandnozzletho-
roughly in hot water.
• Makesurethetwoholesshowninfigure22
are not blocked.
If necessary, clean with a pin.
• Replacethenozzlebyinsertingitandrota-
ting it vigorously upwards into the cappuc-
cino maker.
• Replacethecappuccinomakerbypushingit
upwards and rotating it anticlockwise.
CLEANING AND
MAINTENANCE
Before performing any cleaning operations, leave
the machine to cool down completely and unplug
from the mains power supply. Never immerse
the coffee maker in water. It is an electrical ap-
pliance. Do not use solvents or abrasive deter-
gents to clean the coffee maker. A soft damp
cloth will suffice. Never wash any of the com-
ponents of the coffee maker in the dishwasher.
Cleaning the coffee maker
The following parts of the machine must be cle-
aned regularly:
• Coffee grounds container (A4).
• Drip tray (A14).
• Water tank (A12).
• Coffee spouts (A13), cappuccino maker
nozzle (A11) and cappuccino maker spouts
(A10).
• Pre-ground coffee funnel (A21).
• Inside the machine, accessible after opening
the service door (A2).
• Infuser (A5).
Cleaning the coffee grounds
container
When “EMPTY GROUNDS CONTAINER” is di-
splayed, the grounds container must be emptied
and cleaned.
Until the grounds container has been cleaned,
the appliance continues to display the message
and coffee cannot be made.
To clean:
• Opentheservicedoor(A2)onthefrontof
the appliance (fig. 13), extract the drip tray
(A14) (fig. 14), empty and clean.
• Emptythegroundscontainerandcleantho-
roughly to remove all residues left on the
bottom.
Important! If the drip tray is not emptied
regularly, the water could overflow from the edge
and seep inside or around the coffee maker.
This could damage the appliance and cabinet.
The drip tray is fitted with a level indicator (red)
showing the level of water it contains (fig. 24).
Before the indicator protrudes from the cup tray,
the drip tray must be emptied and cleaned.
Cleaning the drip tray
Important! If the drip tray is not emptied
regularly, the water could overflow from the edge
and seep inside or around the coffee maker.
This could damage the appliance and cabinet.
The drip tray is fitted with a level indicator (red)
showing the level of water it contains (fig. 24).
Before the indicator protrudes from the cup tray,
the drip tray must be emptied and cleaned.
To remove the tray:
1. Open the service door (A2) (fig. 13).
2. Remove the drip tray (A14) and the grounds
container (A4) (fig. A14).
3. Empty the drip tray and grounds container
(A4) and wash them;
4. Remove the drip tray complete with grounds
container (A4).
5. Close the service door.