Teka CLC - Displayed Messages and Troubleshooting Alerts

20
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK • Thewatertankisemptyor
positioned incorrectly.
• Fillthetankwithwaterand/
or insert it correctly, push-
ing it as far as it will go.
GROUND TOO FINE ADJUST
MILL alternating with PRESS
OK
• Thegrindingistoofineand
the coffee is delivered too
slowly.
• The machine cannot make
coffee as there is air in the
hydraulic circuit.
• Turn the grinding adjust-
ment knob one click clock-
wise towards “7”.
• Press the OK button (B9)
and deliver water from the
cappuccino maker
EMPTY GROUNDS
CONTAINER
• Thegroundscontainer(A4)
is too full or more than 3
days have passed since you
first made coffee (this guar-
antees correct hygiene of
the machine).
• Empty the grounds con-
tainer and clean, then re-
place.
Important: when removing
the drip tray, the grounds
container MUST be emp-
tied, even if it is not com-
pletely full.
If this is not done, when you
make the next coffees, the
grounds container may fill
up more than expected and
clog the machine.
INSERT GROUNDS CON-
TAINER
• Aftercleaning,thegrounds
container has not been re-
placed.
• Open theservicedoor and
insert the grounds con-
tainer.
ADD PRE-GROUND COFFEE • The “pre-ground coffee”
function has been selected
without placing any pre-
ground coffee in the funnel.
• Thefunnel(A21)isblocked.
• Extract the appliance and
place pre-ground coffee in
the funnel.
• Empty the funnel with the
help of a knife as described
in the section “Cleaning the
pre-ground coffee funnel”.