Teka CLC - Menu Parameter Configuration; Descaling the Coffee Maker

16
9. Close the service door (A2).
CHANGING AND SETTING
MENU PARAMETERS
After turning the knob (A7) and waiting for
the appliance to be ready, you can use the in-
ternal menu to modify the following parameters
and functions:
• CLOCK
• START TIME 0:00
• AUTO-START NO
• DESCALE NO
• TEMPERATURE MEDIUM
• OFF AFTER 30 MIN
• WATER HARDNESS 4
• DEFAULT VALUES NO
• INSTALL/UNINSTALL FILTER
• FILTER RESET NO (IF INSTALLED)
Setting the clock
To set the clock, proceed as follows:
• PresstheMENUbutton(B6)thenpressthe
NEXT button (B7) repeatedly until the ap-
pliance displays: “CLOCK… 00:00”
• Press the CHANGE button (B8) to set the
clock.
(If you hold the CHANGE button down, the
time is changed rapidly).
• PresstheOKbutton(B9)toconfirm.
• PresstheMENUbuttontoexitprogramming
mode or NEXT to change other parameters.
If auto-start is set, when the appliance is in
stand-by, press any button to display the
auto-start symbol for 5 seconds.
Setting auto-start time
This function programmes the time the machine
will come on automatically to be ready for use.
• Makesuretheclockontheapplianceisset
as described in the previous chapter.
• PresstheMENUbutton(B6)(thelightover
the button comes on) then press the NEXT
button (B7) repeatedly until the appliance
displays: “START TIME 00:00”.
• PresstheCHANGEbutton(B8)tosettheau-
to-start time.
(If you hold the CHANGE button down, the
time is changed rapidly).
• PresstheOKbutton(B9)toconfirm.
• PressNEXTonceandtheappliancedisplays
the message: “AUTO-START NO”.
Press the CHANGE button to modify the fun-
ction (the machine displays “AUTO-START
YES” ).
• PresstheOKbuttontoactivateauto-start;
NOTE: when the machine is off and an au-
to-start time has been set, the symbol
appears alongside the time on the unlit di-
splay.
• PresstheMENUbuttontoexitprogramming
mode or NEXT to change other parameters.
Descaling
Important! Before descaling, make sure
the water softener filter has been removed.
Important! Descaler contains acids which
may irritate the skin and eyes.
It is vital to respect the manufacturer’s safety
warnings given on the descaler pack and the
warnings relating to the procedure to follow in
the event of contact with the skin and eyes.
N.B.! Use the descaler recommended by
the manufacturer only.
Use of other descalers invalidates the guarantee.
Failure to descale the appliance as described also
invalidates the guarantee.
Over time, constant heating up of the water used
to make the coffee leads to limescale building up
in the inner circuits of the appliance.
When “DESCALE” is displayed, the machine re-
quires descaling.
Proceed as follows: