Teka CLC User Manual

8
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
Position the rails on the sides of the cabinet as
shown in the figure.
Fix with the screws, then extract completely.
If the coffee maker is installed over a warmer
drawer (500 W max.), use the top surface of this
as a reference to position the rails.
In this case, there will be no surface to rest the
rails on.
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
Fix the power cable with the clip to avoid it tan-
gling when the appliance is inserted or extracted.
The power cable must be long enough to allow
the appliance to be extracted from the cabinet to
fill the coffee beans container.
The appliance must be earthed in compliance
with legislation.
Electrical connections must be performed by a
qualified electrician in compliance with the ma-
nufacturer’s instructions and legislation in force
in the country of installation.
The electrical socket must be accessible.
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
Position the appliance on the rails, making sure
the pins are correctly inserted in the housings,
then fix it with the screws supplied.
x 4
x 16 x 2
approx. 350mm
x 1
x 4
560 + 1 mm
If necessary, correct alignment of the appliance
by positioning the spacers supplied under or at
the sides of the support.

Teka CLC Specifications

General

Brand	Teka
Model	CLC
Category	Coffee Maker
Language	English