17
3in1 function
When using "3 in 1"combination products, the rinse-aid light are no longer useful. It may be helpful
therefore to switch the rinse aid off.
If you decide to switch to the use of a standard detergent system we advise you to refill rinse aid
compartments.
Memory Function Module
If the dishwasher is switched off through the ON/OFF button, or a current leak happens while the se-
lected washing program is active, the program is not cancelled. The controls use a microprocessor
device, to memorize the information about the selected washing program. Once the machine is again
powered on, the dishwasher will be resumed from the point it was interrupted.
Canceling or modifying a washing program cycle
1: To modify or cancel the carrying out of a washing cycle (being the door opened), it's necessary to
reset the previous programming, by holding pushed the programme selector button ìBî for at least 3
seconds, and the buzzer emits one short warning signal.
2: If the reset operation was successful, a drain phase is started. Once the drain phase is ended, the
dishwasher stands waiting for a new programming
3: A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water. If
this is the case, the detergent dispenser must be refilled.
CB
Notice:
Do not place the tablets in the tub or the cutlery basket as this will result in
poorer wash results. The tablets should be placed in the detergent doser.
Notice:
The usage of 3 in 1 or similar tablets is forbidden when Heat wash,
Rapid Wash and Soak programmes are selected.
To Next Page
Loading...
