Close the door, the delayed start indicator “ G ” blinks , the time-remaining indicator “ F ” will blink and
decrease, the programme will start until the delayed start indicator “ G ” goes out .
16
Delayed start programming
You can delay the start of a programme in increments of 1 hour up to 24 hours.
Switch dishwasher ON.
Press programme button “ B ” to choose the desired programme.
Immediately press the Delayed Start button “ G ”, the delayed start indicator lights, the delayed start
time indicator “ F ” changes to “ ”.
Press the Delayed Start button “ G ” as many times as necessary until the numerical display shows
the required delay.
To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator
goes out.
1/2 Load Button
This button “H” (see" Close-up View (Control Panel) ) makes it possible to wash dishes using only the
upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy
consumption.
To select 1/2 load:
Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”)
Press the 1/2 load button “ H ” , 1/2 load indicator lights.
Close the door, the programme starts automatically.
A
F G
I
H
B
- Please keep in mind that the amount of detergent should also be adapted to the 1/2 load.
To cancel the 1/2 load
while underway
Press programme button “ B ” and hold it in for about 3 seconds.
To Next Page
Loading...
