Teka LP2 400 - Care and Maintenance; Appliance Interior Checks; Filter and Spray Arm Cleaning

Care and maintenance
Overall condition of appliance
Check that no grease or scale has accumulated on the inside of the dishwasher.
If you discover any deposits:
Clean the interior of the dishwasher thorughly with a detergent solution.
Filters
The filters “7”,“8” prevent larger particles of
food in the water from reaching the pump.These
particles may occasionally block the fi lters.
When the appliance has finished washing,
check the filters for particles of food and, if
required, clean.
After undoing the coarse micro-filter “7 ” , the
fi lter unit
“ 8” can be removed. Remove any particles of
food and rinse the fi lters under running water.
Insert the fi lter unit “ 8 ” and tighten the coarse
micro-fi lter.
21
en
Inspect the nozzles in the spray arms for
blocked holes due to remnants of food.
If necessary, pull the lower arm “ 10 ” upwards
and lift it off.
Unscrew the upper spray arm “ 9 ”.
Clean both spray arms under running water.
Refit the spray arms. Ensure that the lower
arm has locked into place and the upper one is
screwed tight.
Spray arms
Lime and remnants of food in the washing water
can block the nozzles in the spray arms “ 9 ” and “
10 ” and the arm mountings.
8
7
9
10
Dishwasher salt
Check the LOW SALT indicator “H”. Top up with
salt, if required.
Rinse-aid
Check the LOW RINSE AID indicator “ C ”, on the front panel. Top up with rinse-aid,if
required.
H
C