Not enough detergent was added to dispenser.
Detergent has insuffcient bleaching properties. Use a detergent containing a chemical
bleaching agent.
Plastic items are discoloured
Not enough detergent was added to dispenser compartment.
Amount of rinse-aid was set too low.
Although water is quite hard, no salt has been put in appliance.
Water softener was set too low.
Lid on salt container is not screwed tight.
If you used a phosphate-free detergent , try a detergent containing phosphates and
compare results.
White stains are left on crockery, glasses have a milky appearance
Selected programme did not include drying function.
Amount of rinse-aid was set too low.
Items were removed from dishwasher too soon.
Dishes,cultlery,etc.have not been dried
Amount of rinse-aid was set too low.
Glasses have a dull appearance
Tea stains or traces of lipstick have not been completely removed
Detergent does not have a suffi cient bleaching effect.
Washing temperature was set too low.
Traces of rust on cutlery
Cutlery is not suffi ciently rustproof.
Salt content in washing water is too high.
Unsuitable detergent was used.
Glasses are not dishwasher-proof.
Glasses become clouded and discoloured; coating cannot be wiped off
Amount of rinse-aid set too high.
Smears left behind on glasses and cutlery; glasses have acquired a
metallic appearance
- Lid on salt container is not screwed tight.
- Too much salt was spilt while fi lling container.
25
en
To Next Page
Loading...
