Teka LP2 400 - Salt Management; Loading the Salt

How to fi ll the salt
7
en
Salt
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifi cally designed
to eliminate lime and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be fi lled as follows:
When the low salt indicator “H” lights, you must
fi ll the salt.
Remove the lower rack and then unscrew and
remove the cap from the salt container;
If you are fi lling the container for the fi rst time, fi ll
it with water;
Place the end of the funnel (supplied) into the
hole and introduce about 2 kg of salt. It is normal
for a small amount of water to come out of the
salt container.
Carefully screw the cap back on.
Important
To prevent the formation of rust, load the salt just before beginning a
wash cycle.
H