Height-Adjustable Products – Expansion Series / Produits réglables en hauteur - Série Expansion
User Guide / Guide d'utilisation
For additional information on this installation contact Technical Support. Pour plus d'informations sur cette installation contactez le support technique.
2019-02-12 L04-50001_R04.DOCX 5 / 10
Memory
To store a position:
• Drive to the required desk height
• Press the “S” button.
• Press a memory button (•, •• ou •••).
To drive to a stored height:
• Press and hold a memory button. The surface will
stop at the stored position.
• Not Applicable To store a position:
• Drive to the required desk height
• Press the “star” button until desired memory
number is displayed
• Press the “star” button for two seconds to store
position
To drive to a stored height:
• Tilt and hold the panel. The surface will stop at
the stored position.
• Tap twice in the direction you want to drive to
automatically reach the next stored position in
the chosen direction.
To reset all memory positions:
• Press the “star” button 5 times so the “no
memory” logo is displayed.
• Press the “star” button for two seconds to
confirm.
Others
• For “reminder” function and Bluetooth® pairing
instructions, Press the “reminder” (clock) button
and scan the QR code displayed or refer to
Teknion web site.
Troubleshooting
Reinitialize the system when:
• the system does not operate properly, move slowly &/or only downward.
• the desk has been moved &/or relocated.
• an actuator (leg) looses its connection to the control box or a connecting cable is pulled out during operation.
• the table impacts an obstruction during operation - more than once. Make sure there are no obstructions in either the up or down directions and carry out
a reinitialization
• the display shows error code E##.
If a reinitialization does not address the issue, contact your facilities representative for assistance.
To Next Page
