To Next PageTo Next PageWhat to do if TekPower Power Supply cannot start up and there is no display?
If your TekPower Power Supply does not start and the display is off, ensure the power source and power cord are functioning correctly. Also, check the fuse. If it's broken, disconnect the power supply and replace the fuse with one of identical rating.
Why is the TekPower Power Supply output unstable?
The unstable output of your TekPower Power Supply might be caused by a couple of things. First, the power supply requires a warm-up period of at least 30 minutes to meet its specifications. Second, the power source voltage might be below the minimum requirement. Make sure that the power source voltage meets the minimum requirement and allow 30 minutes for warm up.
What to do if the voltage drops and the CC indicator is on when operating TekPower TP-3005D Power Supply in CV mode?
If the voltage drops and the CC indicator turns on while operating your TekPower Power Supply in CV mode, it indicates current protection activation because the desired current range is under the circuit gain. To resolve this, adjust the current knob clockwise to increase the range.
General| Model | TP-3005D |
|---|---|
| Type | Linear DC Power Supply |
| Output Voltage | 0-30V |
| Output Current | 0-5A |
| Power Rating | 150W |
| Input Frequency | 50/60Hz |
| Voltage Regulation | ≤ 0.01% + 3mV |
| Line Regulation | ≤ 0.01% + 3mV |
| Load Regulation | ≤ 0.01% + 3mV |
| Ripple & Noise | ≤ 1mVrms |
| Current Display Resolution | 0.01A |
| Display Type | LED |
| Cooling | Fan |
| Protections | Short Circuit |
| Operating Temperature | 0°C to 40°C |
| Input Voltage | 110V/220V AC |
Instructions for preparing and using the instrument before its initial operation.
Guidelines and precautions to follow while the instrument is actively being used.
Procedures for safe shutdown, cooling, and storage after operation.
Defines the environmental and input requirements for optimal instrument operation.
Detailed electrical and performance parameters for constant voltage and current modes.
Overview of the instrument's components and layout.
Detailed explanation of controls and displays on the front of the instrument.
Explanation of connections and features located on the rear of the instrument.
Step-by-step guide on how to adjust and set the desired output voltage.
Procedure for adjusting and establishing the desired output current.
Instructions for safely replacing the internal fuse with a new one.
